Router Advertisement Prefix Option Extension for On-Demand Mobility
draft-feng-dmm-ra-prefixtype-00

Abstract

Router Advertisement / Router Solicitation is one of the ways for hosts to establish network IPv6 connectivity configuration. This document describes an extension to the router advertisement prefix information option to allow the router to specify mobility service type availability to mobile hosts. Mobile hosts can then configure their IP address to the preferred type of mobile connectivity.

Status of This Memo

This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.

Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet-Drafts is at http://datatracker.ietf.org/drafts/current/.

Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."

This Internet-Draft will expire on December 10, 2017.

Copyright Notice

Copyright (c) 2017 IETF Trust and the persons identified as the document authors. All rights reserved.

This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (http://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Simplified BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License.

Table of Contents

• 1. Introduction
• 2. Notational Conventions
• 3. Router Advertisement Prefix Information Option
• 4. Security Considerations
• 5. IANA Considerations
• 6. References
• 6.1. Normative References
• 6.2. Informative References
• Authors' Addresses

1. Introduction

[I-D.ietf-dmm-ondemand-mobility] defines different types of mobility related network services provided by access network to mobile hosts. In particular, it defines different types of prefix continuity types as mobile nodes move between different points of attachments.

This document defines extensions to the prefix information option in the router advertisement message ([RFC4861]) to allow the router to convey mobility services associated with an Ipv6 prefix.

2. Notational Conventions

The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in [RFC2119].

3. Router Advertisement Prefix Information Option

IP prefixes are conveyed in Router Advertisement messages through the Prefix Information Option field ([RFC4861]). These prefix information option fields are used to allow hosts to configure their IPv6 addresses.

For distributed mobility management, there is a need for a network to be able to convey different prefixes for different connectivity scenarios. [I-D.ietf-dmm-ondemand-mobility] defines different service continuity requirements including: Non-Persistent, Session-Lasting, Fixed, and Graceful-replacement. Currently, however, there is no way for a router to specify the continuity type through a router advertisement message.

This document proposes modifying the prefix information option within the router advertisement message to include mobility service options that it is offering to mobile hosts that are attached.

The modified prefix information option fields are shown in the following figure:

       0                   1                   2                   3
       0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
      +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
      |     Type      |    Length     | Prefix Length |L|A| Rsv1|SrvTp|
      +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
      |                         Valid Lifetime                        |
      +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
      |                       Preferred Lifetime                      |
      +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
      |                           Reserved2                           |
      +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
      |                                                               |
      +                                                               +
      |                                                               |
      +                            Prefix                             +
      |                                                               |
      +                                                               +
      |                                                               |
      +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+

Fields:

Type

3

Length

4

Prefix Length

8-bit unsigned integer. The number of leading bits in the Prefix that are valid. The value ranges from 0 to 128.

L

1-bit on-link flag. When set, indicates that this prefix can be used for on-link determination.

A

1-bit autonomous address-configuration flag. When set indicates that this prefix can be used for stateless address configuration.

Rsv1

3-bit unused field. It MUST be initialized to zero by the sender and MUST be ignored by the receiver.

SrvTp

3-bit field that specifies the service type. The field can have the following values:

Non-Persistent -

a non-persistent IP prefix (1)

Session-Lasting -

a session-lasting IP prefix (2)

Fixed -

a fixed IP prefix (3)

Graceful-replacement -

a graceful-replacement IP prefix (4)

The definition of these service types is available in [I-D.ietf-dmm-ondemand-mobility].

0 is reserved and should not be used. All other values (5-7) are reserved for future use.

The value of the Service Type indicates the type of continuity service committed by the network for the associated IPv6 prefix.

Once an IPv6 prefix type is provided, any subsequent messages involving this prefix (lease renewal - for example) must include the IPv6 Continuity Service option with the same service type that was assigned by the server during the initial allocation.

Given the lsit of IPv6 prefixes and their associated mobility service type, the mobile host can then configure its IP address to the appropriate service required by the application

Mobile hosts that do not support this new option should ignore the prefix information option.

Routers should also send an additional prefix information option without the session-type field from time to time for hosts that do not support this new format.

4. Security Considerations

There are no specific security considerations for this option.

5. IANA Considerations

TBD

6. References

6.1. Normative References

6.2. Informative References

Authors' Addresses