Preparation and Comparison of Nicknames
draft-ietf-precis-nickname-01

Abstract

This document describes how to prepare and compare Unicode strings representing nicknames, primarily as used within textual chatrooms. This profile is intended to be used by chatroom technologies based on both the Message Session Relay Protocol (MSRP) and the Extensible Messaging and Presence Protocol (XMPP).

Status of This Memo

This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.

Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet- Drafts is at http:/⁠/⁠datatracker.ietf.org/⁠drafts/⁠current/⁠.

Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."

This Internet-Draft will expire on March 22, 2013.

Copyright Notice

Copyright (c) 2012 IETF Trust and the persons identified as the document authors. All rights reserved.

This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (http:/⁠/⁠trustee.ietf.org/⁠license-⁠info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Simplified BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License.

Table of Contents

• 1. Introduction
• 1.1. Overview
• 1.2. Terminology
• 2. Rules
• 3. Security Considerations
• 3.1. Reuse of PRECIS
• 3.2. Reuse of Unicode
• 3.3. Visually Similar Characters
• 4. IANA Considerations
• 5. References
• 5.1. Normative References
• 5.2. Informative References
• Author's Address

1. Introduction

1.1. Overview

Technologies for textual chatrooms customarily enable participants to specify a nickname for use in the room; e.g., this is true of Internet Relay Chat [RFC2811], Multi-User Chat (MUC) based on the Extensible Messaging and Presence Protocol (XMPP) [XEP-0045], and multi-party chat based on the Message Session Relay Protocol (MSRP) [I-D.ietf-simple-chat]. Recent chatroom technologies also allow internationalized nicknames because they support characters from outside the ASCII range [RFC20], typically by means of the Unicode character set [UNICODE]. Although such nicknames tend to be used primarily for display purposes, they are sometimes used for programmatic purposes as well (e.g., kicking users or avoiding nickname conflicts).

To increase the likelihood that nicknames will work in ways that make sense for typical users throughout the world, this document defines rules for preparing and comparing internationalized nicknames.

1.2. Terminology

Many important terms used in this document are defined in [I-D.ietf-precis-framework], [RFC6365], and [UNICODE]. Relevant XMPP terms are defined in [RFC6120] and [XEP-0045], and relevant MSRP terms are defined in [RFC4975] and [I-D.ietf-simple-chat].

The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in RFC 2119 [RFC2119].

2. Rules

A nickname MUST consist only of Unicode code points that conform to the "FreeClass" base string class defined in [I-D.ietf-precis-framework].

For preparation purposes (most commonly, when a chatroom client generates a nickname from user input for inclusion as a protocol element that represents a "nickname slot"), an application MUST at a minimum ensure that the string conforms to the "FreeClass" base string class defined in [I-D.ietf-precis-framework]; however, it MAY in addition perform the normalization and mapping operations specified below for comparison purposes.

For comparison purposes (e.g., when a chatroom server determines if two nicknames are in conflict during the authorization process), an application MUST treat a nickname as follows, where the operations specified MUST be completed in the order shown (in particular, normalization MUST be performed before all other mapping steps and validity checks, consistent with [I-D.ietf-precis-framework]):

1. The string MUST be normalized using Unicode Normalization Form KC (NFKC). Because NFKC is more "aggressive" in finding matches than other normalization forms (in the terminology of Unicode, it performs both canonical and compatibility decomposition before recomposing code points), this rule helps to reduce the possibility of confusion by increasing the number of characters that would match (e.g., U+2163 ROMAN NUMERAL FOUR would match the combination of U+0049 LATIN CAPITAL LETTER I and U+0056 LATIN CAPITAL LETTER V).
   
   
2. Uppercase and titlecase characters MUST be mapped to their lowercase equivalents. In applications that prohibit conflicting nicknames, this rule helps to reduce the possibility of confusion by ensuring that nicknames differing only by case (e.g., "stpeter" vs. "StPeter") would not be allowed in a chatroom at the same time.
   
   
3. Non-ASCII space characters from the "N" category defined under Section 6.14 of [I-D.ietf-precis-framework] MUST be mapped to U+0020 SPACE.
   
   
4. Other mappings MAY be applied, such as those defined in [I-D.yoneya-precis-mappings]. (Note that mapping of fullwidth and halfwidth characters to their decomposition mappings is not necessary, since those mappings are performed as part of normalization using NFKC.)

For both preparation and comparison, the "Bidi Rule" defined in [RFC5893] applies to the directionality of a nickname.

After all of the foregoing rules have been applied, a nickname MUST NOT be zero bytes in length and MUST NOT be more than 1023 bytes in length (the latter restriction is derived from the length restriction on XMPP resourceparts, see [RFC6122]).

3. Security Considerations

3.1. Reuse of PRECIS

The security considerations described in [I-D.ietf-precis-framework] apply to the "FreeClass" base string class used in this document for nicknames.

3.2. Reuse of Unicode

The security considerations described in [UTR39] apply to the use of Unicode characters in nicknames.

3.3. Visually Similar Characters

Section 10.5 of [I-D.ietf-precis-framework] describes some of the security considerations related to visually similar characters, also called "confusable characters" or "confusables".

Although the mapping rules defined under Section 2 of this document are designed in part to reduce the possibility of confusion about nicknames, this document does not provide more detailed recommendations regarding the handling of visually similar characters, such as those in [UTR39].

4. IANA Considerations

The IANA shall add an entry to the PRECIS Usage Registry for reuse of the PRECIS FreeClass in the preparation and comparison of nicknames.

Application Protocol(s):

MSRP and XMPP.

Base Class:

FreeClass.

Subclassing:

No.

Normalization:

NFKC.

Casemapping:

Map uppercase and titlecase characters to lowercase.

Additional Mappings:

Map non-ASCII space characters to ASCII space.

Directionality:

The "Bidi Rule" defined in RFC 5893 applies.

Specification:

RFC XXXX.

5. References

5.1. Normative References

5.2. Informative References

Author's Address