IUTF8 Terminal Mode in Secure Shell (SSH)
draft-sgtatham-secsh-iutf8-00

Abstract

This document specifies a value for the widely used IUTF8 bit in the Secure Shell terminal modes encoding.

Status of This Memo

This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.

Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet-Drafts is at http://datatracker.ietf.org/drafts/current/.

Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."

This Internet-Draft will expire on November 3, 2016.

Copyright Notice

Copyright (c) 2016 IETF Trust and the persons identified as the document authors. All rights reserved.

This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (http://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Simplified BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License.

Table of Contents

• 1. Introduction
• 2. Conventions Used in this Document
• 3. New terminal mode
• 4. IANA Considerations
• 5. Security Considerations
• 6. Acknowledgements
• 7. References
• 7.1. Normative References
• 7.2. Informative References
• Authors' Addresses

1. Introduction

The Secure Shell (SSH) connection protocol [RFC4254] provides an encoding for terminal modes, used in the "pty-req" channel request type.

A commonly used terminal mode is IUTF8, which indicates that the terminal driver should assume that terminal I/O uses the UTF-8 character encoding. This is typically used by the kernel's terminal driver on the server to decide how many bytes of input to treat as a single logical character during line editing.

SSH currently does not provide an encoding for IUTF8. This document specifies one.

2. Conventions Used in this Document

The key phrases "SHOULD" and "MAY" in this document are to be interpreted as described in [RFC2119].

3. New terminal mode

The opcode value 42 is defined for the IUTF8 terminal mode.

As [RFC4254] section 8 specifies for all opcodes in the range 1 to 159, it is therefore followed by a single uint32 argument. The value 0 indicates that the IUTF8 mode is disabled, and the value 1 indicates that it is enabled.

As with all other encoded terminal modes, the client SHOULD transmit a value for this mode if it knows about one, and the server MAY ignore it.

4. IANA Considerations

This document augments the "Encoding of Terminal Modes" list in section 8 of [RFC4254].

IANA is requested to update the SSH encoded terminal modes registry with the following additional entry:

opcode  mnemonic       description
------  --------       -----------
42      IUTF8          Terminal input and output is assumed to be
                        encoded in UTF-8.