draft-ietf-l3vpn-gre-ip-2547



Network Working Group                                  Yakov Rekhter
Internet Draft                                      Juniper Networks
Expiration Date: April 2005                               Eric Rosen
Network Working Group                                  Cisco Systems


     Use of PE-PE GRE or IP in BGP/MPLS IP Virtual Private Networks

                  draft-ietf-l3vpn-gre-ip-2547-03.txt

Status of this Memo


   This document is an Internet-Draft and is subject to all provisions
   of section 3 of RFC 3667.  By submitting this Internet-Draft, each
   author represents that any applicable patent or other IPR claims of
   which he or she is aware have been or will be disclosed, and any of
   which he or she become aware will be disclosed, in accordance with
   RFC 3668.

   Internet-Drafts are working documents of the Internet Engineering
   Task Force (IETF), its areas, and its working groups.  Note that
   other groups may also distribute working documents as
   Internet-Drafts.

   Internet-Drafts are draft documents valid for a maximum of six months
   and may be updated, replaced, or obsoleted by other documents at any
   time.  It is inappropriate to use Internet-Drafts as reference
   material or to cite them other than as "work in progress."

   The list of current Internet-Drafts can be accessed at
   http://www.ietf.org/ietf/1id-abstracts.txt.

   The list of Internet-Draft Shadow Directories can be accessed at
   http://www.ietf.org/shadow.html.

   This Internet-Draft will expire on March 2, 2005.

Copyright Notice

   Copyright (C) The Internet Society (2004).










draft-ietf-l3vpn-gre-ip-2547-03.txt                             [Page 1]





Internet Draft     draft-ietf-l3vpn-gre-ip-2547-03.txt      October 2004


1. Abstract

   This draft describes a variation of BGP/MPLS IP Virtual Private
   Networks (VPNs) in which the outermost MPLS label of a VPN packet
   (the tunnel label) is replaced with either IP or a Generic Routing
   Encapsulation (GRE).  This enables the VPN packets to be carried over
   non-MPLS networks.


2. Specification of Requirements

   The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
   "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
   document are to be interpreted as described in RFC 2119 [RFC2119].



3. Introduction

   In "conventional" BGP/MPLS IP VPNs ([BGP-MPLS-VPN]), when an ingress
   PE router receives a packet from a CE router, it looks up the
   packet's destination IP address, or in the case of Carriers' Carriers
   the packet's top MPLS label in a VRF (the VRF is chosen based on the
   packet's ingress attachment circuit ([BGP-MPLS-VPN])). As a result of
   this lookup, the (ingress) PE router determines an MPLS label stack,
   a data link header, and an output interface. The label stack is
   prepended to the packet, the data link header is prepended to that,
   and the resulting frame is queued for the output interface.

   The bottom label in the MPLS label stack prepended to the packet is
   called the VPN route label ([BGP-MPLS-VPN]). The VPN route label will
   not be seen until the packet reaches the egress PE router. This label
   controls forwarding of the packet by the egress PE router. The upper
   label in the MPLS label stack is called the tunnel label ([BGP-MPLS-
   VPN]). The purpose of the tunnel label is to cause the packet to be
   delivered to the egress PE router which understands the VPN route
   label.

   What we discuss here are procedures for creating an MPLS packet which
   carries the VPN route label, but does not carry the tunnel label, and
   then using either GRE or IP encapsulation to carry that MPLS packet
   across the network. That is, the tunnel label is replaced with an IP
   header, and in the case of GRE encapsulation a GRE header as well.








draft-ietf-l3vpn-gre-ip-2547-03.txt                             [Page 2]





Internet Draft     draft-ietf-l3vpn-gre-ip-2547-03.txt      October 2004


4. Motivations

   "Conventional" BGP/MPLS IP VPNs require that there be an MPLS Label
   Switched Path (LSP) between a packet's ingress PE router and its
   egress PE router.  This means that a BGP/MPLS IP VPN cannot be
   implemented if there is a part of the path between the ingress and
   egress PE routers which does not support MPLS.

   In order to enable BGP/MPLS IP VPNs to be deployed even when there
   are non-MPLS routers along the path between the ingress and egress PE
   routers, it is desirable to have an alternative which allows the
   tunnel label to be replaced with either IP or (IP + GRE) header.  The
   encapsulation header would have the address of the egress PE router
   in its destination IP address field, and this would cause the packet
   to be delivered to the egress PE router.

   In this procedure, the ingress and egress PE routers themselves MUST
   support MPLS, but that is not an issue, as those routers MUST
   necessarily have BGP/MPLS IP VPN support, whereas the transit routers
   arguably should be able to be "vanilla" routers with no special MPLS
   or VPN support.


5. Specification

   In short, the technical approach specified here is:

      1. Continue to use MPLS to identify a VPN route, by continuing to
      add an MPLS label stack to the VPN packets. Between the ingress
      and the egress PE router the top label of the label stack will
      contain that label (the top label will be the VPN route label).

      2. An MPLS-in-GRE or MPLS-in-IP [MPLS-GRE-IP] encapsulation will
      be used to turn the above MPLS packet back into an IP packet. This
      in effect creates a GRE or an IP tunnel between the ingress PE
      router and the egress PE router.

   The net effect is that an MPLS packet gets sent through a GRE or an
   IP tunnel.


5.1. MPLS-in-IP/MPLS-in-GRE Encapsulation by Ingress PE

   The following description is not meant to specify an implementation
   strategy; any implementation procedure which produces the same result
   is acceptable.

   When an (ingress) PE router receives a packet from a CE router, it



draft-ietf-l3vpn-gre-ip-2547-03.txt                             [Page 3]





Internet Draft     draft-ietf-l3vpn-gre-ip-2547-03.txt      October 2004


   looks up the packet's destination IP address, or in the case of
   Carriers' Carriers the packet's top MPLS label in a VRF (the VRF is
   chosen based on the packet's ingress attachment circuit ([BGP-MPLS-
   VPN])). This enables the (ingress) PE router to find a VPN-IP route.
   The VPN-IP route will have an associated VPN route label and an
   associated BGP Next Hop. The label is pushed on the packet. Then an
   IP (or IP+GRE) encapsulation header is prepended to the packet,
   creating an MPLS-in-IP (or MPLS-in-GRE) encapsulated packet. The IP
   source address field of the encapsulation header will be an address
   of the ingress PE router itself. The IP destination address field of
   the encapsulation header will contain the value of the associated BGP
   Next Hop; this will be an IP address of the egress PE router.

   The effect is to dynamically create an IP (or GRE) tunnel between the
   ingress and egress PE routers. No apriori configuration of the remote
   tunnel endpoints is needed. Note that these tunnels SHOULD NOT be
   IGP-visible links, and routing adjacencies SHOULD NOT be supported
   across these tunnel. Note also that the set of remote tunnel
   endpoints is not known in advance, but is learned dynamically via the
   BGP distribution of VPN-IP routes ([BGP-MPLS-VPN]). The IP address of
   the remote tunnel endpoints is carried in the Network Address of the
   Next Hop field of the MP_REACH_NLRI BGP attribute ([RFC2858]).


5.2. MPLS-in-IP/MPLS-in-GRE Decapsulation by Egress PE

   We assume that every egress PE is also an ingress PE, and hence has
   the ability to decapsulate MPLS-in-IP (or MPLS-in-GRE) packets.
   After decapsulation, the packets SHOULD be delivered to the routing
   function for ordinary MPLS switching.


6. Implications on packet spoofing

   It should be noted that if the tunnel MPLS labels are replaced with
   an unsecured IP encapsulation, like GRE or IP, it becomes more
   difficult to protect the VPNs against spoofed packets. This is
   because a Service Provider (SP) can protect against spoofed MPLS
   packets by the simple expedient of not accepting MPLS packets from
   outside its own boundaries (or more generally by keeping track of
   which labels are validly received over which interfaces, and
   discarding packets which arrive with labels that are not valid for
   their incoming interfaces).

   In contrast to protection against spoofed MPLS packets, protection
   against spoofed IP packets requires having all the boundary routers
   of the SP to perform filtering; either (a) filtering out packets from
   "outside" of the SP which are addressed to PE routers, or (b)



draft-ietf-l3vpn-gre-ip-2547-03.txt                             [Page 4]





Internet Draft     draft-ietf-l3vpn-gre-ip-2547-03.txt      October 2004


   filtering out packets from "outside" of the SP which have source
   addresses that belong "inside" and, in addition, filtering on each PE
   all packets which have source addresses that belong "outside" of the
   SP. The maintenance of these filter lists can be management-
   intensive, and, depending on the implementation, their use at all
   boundary routers may affect the performance seen by all traffic
   entering the SP's network. However, such filters may be required for
   reasons other than protection against spoofing of VPN packets, in
   which case the additional maintenance overhead of these filters to
   protect (among other things) against spoofing of VPN packets may be
   of no practical significance. Note that allocating IP addresses used
   for GRE or IP tunnels out of a single (or a small number of) IP block
   could simplify maintenance of the filters.

   The filtering described in the previous paragraph works only within a
   single SP network. It is not clear whether (and how) this filtering
   could be extended to support multiple SP networks. That makes the
   scheme described in this document fairly problematic in the multi-
   provider environment.


7. Security Considerations

   Security considerations in [MPLS-GRE-IP] apply here as well.
   Additional security issues are discussed in the section "Implications
   on packet spoofing" above.


8. IANA Considerations

   No actions for IANA required.




















draft-ietf-l3vpn-gre-ip-2547-03.txt                             [Page 5]





Internet Draft     draft-ietf-l3vpn-gre-ip-2547-03.txt      October 2004


9. Intellectual Property Statement

   The IETF takes no position regarding the validity or scope of any
   Intellectual Property Rights or other rights that might be claimed to
   pertain to the implementation or use of the technology described in
   this document or the extent to which any license under such rights
   might or might not be available; nor does it represent that it has
   made any independent effort to identify any such rights.  Information
   on the procedures with respect to rights in RFC documents can be
   found in BCP 78 and BCP 79.

   Copies of IPR disclosures made to the IETF Secretariat and any
   assurances of licenses to be made available, or the result of an
   attempt made to obtain a general license or permission for the use of
   such proprietary rights by implementers or users of this
   specification can be obtained from the IETF on-line IPR repository at
   http://www.ietf.org/ipr.

   The IETF invites any interested party to bring to its attention any
   copyrights, patents or patent applications, or other proprietary
   rights that may cover technology that may be required to implement
   this standard.  Please address the information to the IETF at
   ietf-ipr at ietf.org.



10. Disclaimer of Validity

   This document and the information contained herein are provided on an
   "AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS
   OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE INTERNET
   ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED,
   INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE
   INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED
   WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
















draft-ietf-l3vpn-gre-ip-2547-03.txt                             [Page 6]





Internet Draft     draft-ietf-l3vpn-gre-ip-2547-03.txt      October 2004


11. Copyright Statement

   Copyright (C) The Internet Society (2004).  This document is subject
   to the rights, licenses and restrictions contained in BCP 78, and
   except as set forth therein, the authors retain all their rights.


12. Acknowledgment

   Most of the text in this document is "borrowed" almost verbatim from
   draft-rosen-ppvpn-ipsec-2547-00.txt.

   Funding for the RFC Editor function is currently provided by the
   Internet Society.


13. Normative References

   [BGP-MPLS-VPN] "BGP/MPLS IP VPNs", Rosen E., Rekhter, Y., draft-ietf-
   l3vpn-rfc2547bis-01.txt

   [MPLS-GRE-IP] "Encapsulating MPLS in IP or Generic Routing
   Encapsulation (GRE)", Rekhter, Y., Rosen, E., draft-ietf-mpls-in-ip-
   or-gre-06.txt

   [RFC2119] Bradner, S., "Key words for use in RFCs to Indicate
   Requirement Levels", BCP 14, RFC 2119, March 1997.

   [RFC2858] "Multiprotocol Extensions for BGP-4", Rekhter, Y., Chandra,
   R., Katz, D., RFC2858, June 2000


14. Authors' Addresses


Yakov Rekhter
Juniper Networks
E-mail: yakov@juniper.net

Eric C. Rosen
Cisco Systems, Inc.
E-mail: erosen@cisco.com









draft-ietf-l3vpn-gre-ip-2547-03.txt                             [Page 7]