rfc2395
Network Working Group R. Friend
Request for Comments: 2395 R. Monsour
Category: Informational Hi/fn, Inc.
December 1998
IP Payload Compression Using LZS
Status of this Memo
This memo provides information for the Internet community. It does
not specify an Internet standard of any kind. Distribution of this
memo is unlimited.
Copyright Notice
Copyright (C) The Internet Society (1998). All Rights Reserved.
Abstract
This document describes a compression method based on the LZS
compression algorithm. This document defines the application of the
LZS algorithm to the IP Payload Compression Protocol [IPCOMP].
[IPCOMP] defines a method for applying lossless compression to the
payloads of Internet Protocol datagrams.
Table of Contents
1. Introduction...................................................2
1.1 General....................................................2
1.2 Background of LZS Compression..............................2
1.3 Licensing..................................................3
1.4 Specification of Requirements..............................3
2. Compression Process............................................3
2.1 Compression History........................................3
2.2 Compression Encoding Format................................3
2.3 Padding....................................................4
3. Decompression Process..........................................4
4. IPComp Association (IPCA) Parameters...........................4
4.1 ISAKMP Transform ID........................................5
4.2 ISAKMP Security Association Attributes.....................5
4.3 Manual configuration.......................................5
4.4 Minimum packet size threshold..............................5
4.5 Compressibility test.......................................5
5. Security Considerations........................................5
6. Acknowledgements...............................................5
7. References.....................................................6
8. Authors' Addresses.............................................7
Friend & Monsour Informational [Page 1]
RFC 2395 IP Payload Compression Using LZS December 1998
9. Appendix: Compression Efficiency versus Datagram Size..........8
10. Full Copyright Statement......................................9
1. Introduction
1.1 General
This document specifies the application of LZS compression, a
lossless compression algorithm, to IP datagram payloads. This
document is to be used in conjunction with the IP Payload Compression
Protocol [IPCOMP]. This specification assumes a thorough
understanding of the IPComp protocol.
1.2 Background of LZS Compression
Starting with a sliding window compression history, similar to [LZ1],
Hi/fn developed a new, enhanced compression algorithm identified as
LZS. The LZS algorithm is a general purpose lossless compression
algorithm for use with a wide variety of data types. Its encoding
method is very efficient, providing compression for strings as short
as two octets in length.
The LZS algorithm uses a sliding window of 2,048 bytes. During
compression, redundant sequences of data are replaced with tokens
that represent those sequences. During decompression, the original
sequences are substituted for the tokens in such a way that the
original data is exactly recovered. LZS differs from lossy
compression algorithms, such as those often used for video
compression, that do not exactly reproduce the original data.
The details of LZS compression can be found in [ANSI94].
The efficiency of the LZS algorithm depends on the degree of
redundancy in the original data. A table of compression ratios for
the [Calgary] Corpus file set is provided in the appendix in Section
7.
Friend & Monsour Informational [Page 2]
RFC 2395 IP Payload Compression Using LZS December 1998
1.3 Licensing
Hi/fn, Inc. holds patents on the LZS algorithm. Licenses for a
reference implementation are available for use in IPPCP, IPSec, TLS
and PPP applications at no cost. Source and object licenses are
available on a non-discriminatory basis. Hardware implementations are
also available. For more information, contact Hi/fn at the address
listed with the authors' addresses.
1.4 Specification of Requirements
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
"SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
document are to be interpreted as described in [RFC-2119].
2. Compression Process
2.1 Compression History
The sender MUST reset the compression history prior to processing
each datagram's payload. This ensures that each datagram's payload
can be decompressed independently of any other, as is needed when
datagrams are received out of order.
The sender MUST flush the compressor each time it transmits a
compressed datagram. Flushing means that all data going into the
compressor is included in the output, i.e., no data is held back in
the hope of achieving better compression. Flushing is necessary to
prevent a datagram's data from spilling over into a later datagram.
2.2 Compression Encoding Format
The input to the payload compression algorithm is an IP datagram
payload. The output of the algorithm is a new (and hopefully smaller)
payload. The output payload contains the input payload's data in
either compressed or uncompressed format. The input and output
payloads are each an integral number of bytes in length.
If the uncompressed form is used, the output payload is identical to
the input payload and the IPComp header is omitted. If the
compressed form is used, the output payload is prepended with the
IPComp header and encoded as defined in [ANSI94], which is repeated
here for informational purposes ONLY.
<Compressed Stream> := [<Compressed String>] <End Marker>
<Compressed String> := 0 <Raw Byte> | 1 <Compressed Bytes>
<Raw Byte> := <b><b><b><b><b><b><b><b> (8-bit byte)
<Compressed Bytes> := <Offset> <Length>
Friend & Monsour Informational [Page 3]
RFC 2395 IP Payload Compression Using LZS December 1998
<Offset> := 1 <b><b><b><b><b><b><b> | (7-bit offset)
0 <b><b><b><b><b><b><b><b><b><b><b> (11-bit offset)
<End Marker> := 110000000
<b> := 1 | 0
<Length> :=
00 = 2 1111 0110 = 14
01 = 3 1111 0111 = 15
10 = 4 1111 1000 = 16
1100 = 5 1111 1001 = 17
1101 = 6 1111 1010 = 18
1110 = 7 1111 1011 = 19
1111 0000 = 8 1111 1100 = 20
1111 0001 = 9 1111 1101 = 21
1111 0010 = 10 1111 1110 = 22
1111 0011 = 11 1111 1111 0000 = 23
1111 0100 = 12 1111 1111 0001 = 24
1111 0101 = 13 ...
2.3 Padding
A datagram payload compressed using LZS always ends with the last
compressed data byte (also known as the <end marker>), which is used
to disambiguate padding. This allows trailing bits as well as bytes
to be considered padding.
The size of a compressed payload MUST be in whole octet units.
3. Decompression Process
If the received datagram is compressed, the receiver MUST reset the
decompression history prior to processing the datagram. This ensures
that each datagram can be decompressed independently of any other, as
is needed when datagrams are received out of order. Following the
reset of the decompression history, the receiver decompresses the
Payload Data field according to the encoding specified in section 3.2
of [ANSI94].
If the received datagram is not compressed, the receiver needs to
perform no decompression processing and the Payload Data field of the
datagram is ready for processing by the next protocol layer.
4. IPComp Association (IPCA) Parameters
ISAKMP MAY be used to negotiate the use of the LZS compression method
to establish an IPCA, as defined in [IPCOMP].
Friend & Monsour Informational [Page 4]
RFC 2395 IP Payload Compression Using LZS December 1998
4.1 ISAKMP Transform ID
The LZS Transform ID as IPCOMP_LZS, as specified in The Internet IP
Security Domain of Interpretation [SECDOI]. This value is used to
negotiate the LZS compression algorithm under the ISAKMP protocol.
4.2 ISAKMP Security Association Attributes
There are no other parameters required for LZS compression negotiated
under ISAKMP.
4.3 Manual configuration
The CPI value IPCOMP_LZS is used for a manually configured IPComp
Compression Associations.
4.4 Minimum packet size threshold
As stated in [IPCOMP], small packets may not compress well. Informal
tests using the LZS algorithm over the Calgary Corpus data set show
that the average payload size that may produce expanded data is
approximately 90 bytes. Thus implementations may not want to attempt
to compress payloads smaller than 90 bytes.
4.5 Compressibility test
There is no adaptive algorithm embodied in the LZS algorithm, for
compressibility testing, as referenced in [IPCOMP].
5. Security Considerations
This document does not add any further security considerations that
[IPCOMP] and [Deutsch96] have already declared.
6. Acknowledgments
The LZS details presented here are similar to those in PPP LZS-DCP
Compression Protocol (LZS-DCP), [RFC-1967].
The author wishes to thank the participants of the IPPCP working
group mailing list whose discussion is currently active and is
working to generate the protocol specification for integrating
compression with IP.
Friend & Monsour Informational [Page 5]
RFC 2395 IP Payload Compression Using LZS December 1998
7. References
[AH] Kent, S., and R., Atkinson, "IP Authentication Header",
RFC 2402, November 1998.
[ANSI94] American National Standards Institute, Inc., "Data
Compression Method for Information Systems," ANSI X3.241-
1994, August 1994.
[Calgary] Text Compression Corpus, University of Calgary, available
at ftp://ftp.cpsc.ucalgary.ca/pub/projects/text.
compression.corpus.
[IPCOMP] Shacham, A., "IP Payload Compression Protocol (IPComp)",
RFC 2393, December 1998.
[LZ1] Lempel, A., and Ziv, J., "A Universal Algorithm for
Sequential Data Compression", IEEE Transactions On
Information Theory, Vol. IT-23, No. 3, May 1977.
[RFC-1962] Rand, D., "The PPP Compression Control Protocol (CCP)",
RFC 1962, June 1996.
[RFC-1967] Schneider, K., and R. Friend, "PPP LZS-DCP Compression
Protocol (LZS-DCP)", RFC 1967, August 1996.
[RFC-2003] Perkins, C., "IP Encapsulation within IP", RFC 2003,
October 1996.
[RFC-2119] Bradner, S., "Key words for use in RFCs to Indicate
Requirement Levels", BCP 14, RFC 2119, March 1997.
[SECDOI] Piper, D., "The Internet IP Security Domain of
Interpretation for ISAKMP", RFC 2407, November 1998.
Friend & Monsour Informational [Page 6]
RFC 2395 IP Payload Compression Using LZS December 1998
8. Authors' Addresses
Robert Friend
Hi/fn Inc.
5973 Avenida Encinas
Suite 110
Carlsbad, CA 92008
EMail: rfriend@hifn.com
Robert Monsour
Hi/fn Inc.
2105 Hamilton Avenue
Suite 230
San Jose, CA 95125
EMail: rmonsour@hifn.com
Friend & Monsour Informational [Page 7]
RFC 2395 IP Payload Compression Using LZS December 1998
9. Appendix: Compression Efficiency versus Datagram Size
The following table offers some guidance on the compression
efficiency that can be achieved as a function of datagram size. Each
entry in the table shows the compression ratio that was achieved when
LZS was applied to a test file using datagrams of a specified size.
The test file was the University of Calgary Text Compression Corpus
[Calgary]. The Calgary Corpus consists of 18 files with a total size
(all files) of 3.278MB.
Datagram size,|
bytes | 64 128 256 512 1024 2048 4096 8192 16384
--------------|----------------------------------------------------
Compression |1.18 1.28 1.43 1.58 1.74 1.91 2.04 2.11 2.14
ratio |
Friend & Monsour Informational [Page 8]
RFC 2395 IP Payload Compression Using LZS December 1998
10. Full Copyright Statement
Copyright (C) The Internet Society (1998). All Rights Reserved.
This document and translations of it may be copied and furnished to
others, and derivative works that comment on or otherwise explain it
or assist in its implementation may be prepared, copied, published
and distributed, in whole or in part, without restriction of any
kind, provided that the above copyright notice and this paragraph are
included on all such copies and derivative works. However, this
document itself may not be modified in any way, such as by removing
the copyright notice or references to the Internet Society or other
Internet organizations, except as needed for the purpose of
developing Internet standards in which case the procedures for
copyrights defined in the Internet Standards process must be
followed, or as required to translate it into languages other than
English.
The limited permissions granted above are perpetual and will not be
revoked by the Internet Society or its successors or assigns.
This document and the information contained herein is provided on an
"AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING
TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION
HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Friend & Monsour Informational [Page 9]
ERRATA
