rfc2984









Network Working Group                                           C. Adams
Request for Comments: 2984                          Entrust Technologies
Category: Standards Track                                   October 2000


            Use of the CAST-128 Encryption Algorithm in CMS

Status of this Memo

   This document specifies an Internet standards track protocol for the
   Internet community, and requests discussion and suggestions for
   improvements.  Please refer to the current edition of the "Internet
   Official Protocol Standards" (STD 1) for the standardization state
   and status of this protocol.  Distribution of this memo is unlimited.

Copyright Notice

   Copyright (C) The Internet Society (2000).  All Rights Reserved.

Abstract

   This document specifies how to incorporate CAST-128 (RFC2144) into
   the S/MIME Cryptographic Message Syntax (CMS) as an additional
   algorithm for symmetric encryption.  The relevant OIDs and processing
   steps are provided so that CAST-128 may be included in the CMS
   specification (RFC2630) for symmetric content and key encryption.

   The key words "MUST", "MUST NOT", "REQUIRED", "SHOULD", "SHOULD NOT",
   "RECOMMENDED", "MAY", and "OPTIONAL" in this document (in uppercase,
   as shown) are to be interpreted as described in [RFC2119].

1. Motivation

   S/MIME (Secure/Multipurpose Internet Mail Extensions) [SMIME2,
   SMIME3] is a set of specifications for the secure transport of MIME
   objects.  In the current (S/MIME v3) specifications the mandatory-
   to-implement symmetric algorithm for content encryption and key
   encryption is triple-DES (3DES).  While this is perfectly acceptable
   in many cases because the security of 3DES is generally considered to
   be high, for some environments 3DES may be seen to be too slow.  In
   part to help alleviate such performance concerns, S/MIME has allowed
   any number of (optional) additional algorithms to be used for
   symmetric content and key encryption.

   The CAST-128 encryption algorithm [RFC2144, Adams] is a well-studied
   symmetric cipher that has a number of appealing features, including
   relatively high performance and a variable key size (from 40 bits to
   128 bits).  It is available royalty-free and license-free for



Adams                       Standards Track                     [Page 1]

RFC 2984                    CAST-128 in CMS                 October 2000


   commercial and non-commercial uses worldwide [IPR], and therefore is
   widely used in a number of applications around the Internet.  It thus
   seems to be a suitable optional encryption algorithm for S/MIME.

   This document describes how to use CAST-128 within the S/MIME CMS
   specification.

2. Specification

   This section provides the OIDs and processing information necessary
   for CAST-128 to be used for content and key encryption in CMS.

2.1 OIDs for Content and Key Encryption

   CAST-128 is added to the set of optional symmetric encryption
   algorithms in CMS by providing two unique object identifiers (OIDs).
   One OID defines the content encryption algorithm and the other
   defines the key encryption algorithm.  Thus a CMS agent can apply
   CAST-128 either for content or key encryption by selecting the
   corresponding object identifier, supplying the required parameter,
   and starting the program code.

   For content encryption the use of CAST-128 in cipher block chaining
   (CBC) mode is RECOMMENDED.  The key length is variable (from 40 to
   128 bits in 1-octet increments).

   The CAST-128 content-encryption algorithm in CBC mode has the
   following object identifier:

     cast5CBC OBJECT IDENTIFIER ::= {iso(1) member-body(2)
         us(840) nt(113533) nsn(7) algorithms(66) 10}

   The parameter associated with this object identifier contains the
   initial vector IV and the key length:

     cast5CBCParameters ::= SEQUENCE {
         iv         OCTET STRING DEFAULT 0,
         -- Initialization vector
         keyLength  INTEGER
         -- Key length, in bits
     }

   Comments regarding the use of the IV may be found in [RFC2144].

   The key-wrap/unwrap procedures used to encrypt/decrypt a CAST-128
   content-encryption key with a CAST-128 key-encryption key are
   specified in Section 2.2.  Generation and distribution of key-
   encryption keys are beyond the scope of this document.



Adams                       Standards Track                     [Page 2]

RFC 2984                    CAST-128 in CMS                 October 2000


   The CAST-128 key-encryption algorithm has the following object
   identifier:

     cast5CMSkeywrap OBJECT IDENTIFIER ::= { iso(1)
         member-body(2) us(840) nt(113533) nsn(7)
         algorithms(66) 15}

   The parameter associated with this object identifier contains only
   the key length (because the key wrapping procedure itself defines how
   and when to use an IV):

     cast5CMSkeywrapParameter ::= INTEGER
       -- key length, in bits

2.2 Key Wrapping and Unwrapping

   CAST-128 key wrapping and unwrapping is done in conformance with CMS
   [RFC2630].

2.2.1 CAST-128 Key Wrap

   Key wrapping with CAST-128 is identical to [RFC2630], Sections 12.6.1
   and 12.6.4, with "RC2" replaced by "CAST-128" in the introduction to
   12.6.4.  Only 128-bit CAST-128 keys may be used as key-encryption
   keys, and they MUST be used with the cast5CMSkeywrapParameter set to
   128.  It is RECOMMENDED that the size of the content-encryption key
   and the size of the key-encryption key be equal (since the security
   of the content will be at most the smaller of these two values).

2.2.2 CAST-128 Key Unwrap

   Key unwrapping with CAST-128 is identical to [RFC2630], Sections
   12.6.1 and 12.6.5, with "RC2" replaced by "CAST-128" in the
   introduction to 12.6.5.

3. Using CAST-128 in S/MIME Clients

   An S/MIME client SHOULD announce the set of cryptographic functions
   it supports by using the S/MIME capabilities attribute.  This
   attribute provides a partial list of OIDs of cryptographic functions
   and MUST be signed by the client.  The functions' OIDs SHOULD be
   logically separated in functional categories and MUST be ordered with
   respect to their preference.  If an S/MIME client is required to
   support symmetric encryption with CAST-128, the capabilities
   attribute MUST contain the cast5CBC OID specified above in the
   category of symmetric algorithms.  The parameter associated with this
   OID (see above) MUST be used to indicate supported key length.  For
   example, when the supported key length is 128 bits, the



Adams                       Standards Track                     [Page 3]

RFC 2984                    CAST-128 in CMS                 October 2000


   SMIMECapability SEQUENCE representing CAST-128 MUST be DER-encoded as
   the following hexadecimal string:
       301106092A864886F67D07420A300402020080.

   When a sending agent creates an encrypted message, it has to decide
   which type of encryption algorithm to use.  In general the decision
   process involves information obtained from the capabilities lists
   included in messages received from the recipient, as well as other
   information such as private agreements, user preferences, legal
   restrictions, and so on. If users require CAST-128 for symmetric
   encryption, it MUST be supported by the S/MIME clients on both the
   sending and receiving side, and it MUST be set in the user
   preferences.

4. Security Considerations

   This document specifies the use of the CAST-128 symmetric cipher for
   encrypting the content of a CMS message and for encrypting the
   symmetric key used to encrypt the content of a CMS message. Although
   CAST-128 allows keys of variable length to be used, it must be
   recognized that smaller key sizes (e.g., 40, 56, or 64 bits) may be
   unacceptably weak for some environments.  The use of larger key sizes
   (e.g., 128 bits) is always RECOMMENDED (when relevant import, export,
   or other laws permit).  It is also RECOMMENDED that the size of the
   content-encryption key and the size of the key-encryption key be
   equal (since the security of the content will be at most the smaller
   of these two values).

References

   [Adams]   C. Adams, "Constructing Symmetric Ciphers using the CAST
             Design Procedure", Designs, Codes, and Cryptography,
             vol.12, no.3, November 1997, pp.71-104.

   [IPR]     See the "IETF Page of Intellectual Property Rights
             Notices", http://www.ietf.cnri.reston.va.us/ipr.html

   [RFC2144] Adams, C., "The CAST-128 Encryption Algorithm", RFC 2144,
             May 1997.

   [RFC2119] Bradner, S., "Key words for use in RFCs to Indicate
             Requirement Levels", BCP 14, RFC 2119, March 1997.

   [RFC2630] Housley, R., "Cryptographic Message Syntax", RFC 2630, June
             1999.






Adams                       Standards Track                     [Page 4]

RFC 2984                    CAST-128 in CMS                 October 2000


   [SMIME2]  Dusse, S., Hoffman, P., Ramsdell, B., Lundblade, L. and L.
             Repka, "S/MIME Version 2 Message Specification", RFC 2311,
             March 1998.

             Dusse, S., Hoffman, P., Ramsdell, B. and J. Weinstein,
             "S/MIME Version 2 Certificate Handling", RFC 2312, March
             1998.

   [SMIME3]  Ramsdell, B., "S/MIME Version 3 Certificate Handling", RFC
             2632, June 1999.

             Ramsdell, B., "S/MIME Version 3 Message Specification", RFC
             2633, June 1999.

Author's Address

   Carlisle Adams
   Entrust Technologies
   1000 Innovation Drive,
   Kanata, Ontario, Canada K2K 3E7

   EMail: cadams@entrust.com





























Adams                       Standards Track                     [Page 5]

RFC 2984                    CAST-128 in CMS                 October 2000


Full Copyright Statement

   Copyright (C) The Internet Society (2000).  All Rights Reserved.

   This document and translations of it may be copied and furnished to
   others, and derivative works that comment on or otherwise explain it
   or assist in its implementation may be prepared, copied, published
   and distributed, in whole or in part, without restriction of any
   kind, provided that the above copyright notice and this paragraph are
   included on all such copies and derivative works.  However, this
   document itself may not be modified in any way, such as by removing
   the copyright notice or references to the Internet Society or other
   Internet organizations, except as needed for the purpose of
   developing Internet standards in which case the procedures for
   copyrights defined in the Internet Standards process must be
   followed, or as required to translate it into languages other than
   English.

   The limited permissions granted above are perpetual and will not be
   revoked by the Internet Society or its successors or assigns.

   This document and the information contained herein is provided on an
   "AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING
   TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
   BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION
   HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF
   MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

Acknowledgement

   Funding for the RFC Editor function is currently provided by the
   Internet Society.



















Adams                       Standards Track                     [Page 6]



ERRATA